Can’t Access Netgear Genie Setup Wizard? Let’s Fix!

 

Whether you want to set up a Netgear WiFi range extender for the first time or simply tweak its settings, accessing the Netgear Genie setup wizard is quite important. However, if that is exactly what you aren’t able to do, then you are in trouble. But, we have the solution to ease out the worry lines on your forehead. So, walk through the article and get to learn about various tips that can help you access the Netgear Genie smart setup wizard with ease.

Why Can’t You Access Netgear Genie Setup Wizard?

Listed below are some contributing reasons that might be stopping you from accessing the Netgear Genie smart setup wizard:

1. Your internet connection isn’t strong enough.

2.  The connection between your Netgear extender and WiFi router is weak.

3.  You haven’t updated the firmware of your range extender.

4.  By chance, you’ve used incorrect login credentials to log in to your extender.

5.  Technical glitches can also stop you from successfully accessing the Netgear Genie smart setup wizard.

Now that you why you can’t access the Netgear Genie setup wizard, take the help of the below-mentioned troubleshooting to fix the issue.

Fixed: Can’t Access Netgear Genie Setup Wizard

  1. Reboot Your Netgear Extender

Before you do anything else, reboot your Netgear wireless range extender. Here are the steps you need to go through in order to give your device a restart:

1. Disconnect every WiFi-enabled device connected to your extender’s network.

2. Power off your Netgear extender and unplug it from the wall outlet.

3. Wait for some time.

4.  Then, plug your Netgear wireless range extender back into a wall socket.

5.  Turn on the device.

If you are still not able to access the Netgear Genie smart setup wizard, then keep reading.

  1. Use the Correct Login Credentials

As mentioned above, if you aren’t using the correct login credentials, then also you can fail to access the Netgear Genie smart setup wizard.

Therefore, make sure that you are entering the correct login username and password before hitting the Log In button.

If you are not sure regarding the default admin details of your Netgear WiFi range extender, then it is recommended that you refer to the user manual.

  1. Update Extender’s Firmware

Another thing that you can do to successfully access the Netgear Genie smart setup wizard is to update the firmware of your range extender. Don’t worry; updating the firmware of your device is not that difficult.

On the contrary, it is quite easy. All you need to do is, follow the step-by-step guidelines mentioned in the user manual.

  1. Check the Internet Connection

Chances are that the connection between your Netgear extender and router is not stable. If that is the case, then it is recommended that you check the Ethernet cable you’ve used to connect your devices.

If the Ethernet cable is worn out or damaged from anywhere, don’t hesitate even for a second before getting it replaced.

  1. Reset Your Netgear Extender

If sadly nothing worked for you in troubleshooting the issue you are facing with your device, then it is highly advised that you perform factory default reset.

Here are the steps that will help your reset your Netgear wireless range extender:

1.  Look for the Reset button located at the bottom of your extender.

2.  Once found, carefully press it using an oil pin or paper clip.

3.  Now, wait for a couple of seconds.

The minute you are done resetting your wireless device, reconfigure it by accessing the mywifiext administrative page.

The Bottom Line

Here’s to hope that the troubleshooting tips mentioned in this post helped you access the Netgear Genie smart setup wizard without any difficulty. If they did, don’t forget to leave a word of appreciation in the comment section below.